raw_pencils_grande.jpg
Shop

Limited Raw Brass and Aluminum Twist Bullet Pencil

from 40.50

Our take on vintage Americana.  Bullet pencils were common promotional items given by a wide range of companies in the mid 1900's.  Today these vintage pencils are sought after by collectors.

First run of fifty raw brass and fifty raw aluminum bullet pencil tubes.  These pieces are not treated in any way, fresh ofF the machine.  They will get roughed up and patina over time developing their own personality.  Pencils will be shipped with the pink erasers. 

Each one will include a numbered card that includes the machine date and machinist name.

Included:

Each one will include a numbered card that includes the machine date and machinist name

Raw Brass tube with Rounded or Pointed Brass Bullet tip

or

Raw Aluminum tube with Rounded or Pointed Aluminum Bullet tip

3 Palomino Blackwing 602 Pencil Stubs

2 Extra Pink Erasers

 

Color:
Bullet Tip:
Quantity:
Add To Cart
raw_pencils_grande.jpg
raw_close_up_grande.jpg
raw_close_up_2_grande.jpg

Additional Info

One word of caution. The bullet design is such that at certain points in the metal it is very thin. It should not be an issue once the pencil is properly inserted but please use caution when putting the pencil into a tight pocket (like a back pocket in particular)


The bullet of the Twist was designed to hold most pencils on the market but for some thinner and round pencils the fit may be a bit loose. An easy hack is to simply wrap a piece of scotch tape around the portion of the pencil nub that will fit into the bullet. This should provide a nice stable hold.

All Twist are delivered with one nub loaded and two extra pencil nubs. You will see that the non-sharpened end has been twisted in a pencil sharpener to knock off the edges. This is done to allow the thicker pencils, like the Blackwing 602 to sit flush into the bullet. This is only needed if you have a hard time getting a nub into the bullet.

Twisting thicker pencils in can be difficult. There are a couple solutions to make sure you get the pencil in deep enough into the bullet. One is to use the rubber kitchen jar openers, this will help save your fingers! The other solution is to slightly sand or scrap off (with an X-acto knife) some of the paint at the end of the nub (about a 1/2 inch). This will allow the pencil to slide in easier and still twist deep into the threads. Pencil nubs are now shipped with the paint scarped off the edges of the pencil.

It is important to twist the pencil nub deep into the bullet. The best way to determine if it is deep enough is to lay the nub next to the bullet prior to installing. It should go to a point equal to the set of threads toward the round (or point) end of the bullet. If the pencil nub has writing on it you can use that as a guide or simply score it with a knife.